RAMCO HILUX

India's best rated Boards & Tiles for Wall, Ceiling, Panel Systems. It introduced the innovative Calcium Silicate Board, a versatile building material, using Japanese technology from the ASK Corporation, Japan.Dealer,Manufacturer,India,producers

Ceiling Solution      >>       INSTALLATION
  • SUSPENDED CEILINGS
  • STRUCTURAL STEEL CLADDING
  • DECORATION
  • Seamless Finish
    Exposed Grid System
    DECORATION

    Hilux Calcium Silicate Board surface can be decorated with most type of paints, wall papers, ceramic tiles and hard laminate up to 1 mm thickness, after jointing and finishing.

    PAINTS

    Most forms of paints can be applied to the Hilux Calcium Silicate Board surface. Apply oil based cement primer before applying putty or paint to achieve good finish.

    HARD LAMINATES

    Hard laminates up to maximum 1 mm thickness can be laminated to the board surface after doing Jointing and finishing as under:

    • Sand the whole surface with a sand paper to make it even and remove the dust with a cloth
    • Sand the back surface of the laminate with sand paper to make it rough 2
    • Use 16 ft area of the laminate at one time
    • Apply Fevicol SR-998 on the laminate surface and leave it for some time, to get sticky
    • Apply the Fevicol SR-998 to the Hilux Calcium Silicate Board surface
    • Place the laminate against the board surface, matching the required line and press it hard enough with a cloth, from one end to the other, to remove air between the two surfaces
    • Please see that no air is trapped between the two surfaces
    • Please do not try to touch this surface for a minimum of two hours

    NOTE:

    It is essential that the Fevicol is first applied to the laminate and not to the board surface. The board surface sucks the adhesive much faster than the laminate and gets dry, which causes temporary sticking of laminate, which may leave the surface after some time.

    Ceramic Tiles

    Ceramic tiles can be applied to the Hilux Calcium Silicate Board surface by using branded tile adhesive.

    Cornices/Mouldings

    Ready made cornices and mouldings can be screw fixed to the board surface. POP cornices cannot be made at site because the board surface sucks the water from POP and it may get cracks. However, casted POP cornices can be screw fixed to the board surface.

    RAMCO HILUX
    Downloads
    Clean Room Brochure
    Board Brochure
    Tile Brochure
    FireBook
    Sound Book
    Water Book
    RAMCO HILUX
    RAMCO HILUX
    2016 © Ramco Industries Limited